The following section describes the parameters that are common to all Cycle Definition events.
mom_cycle_status
Cycle status.
Values: ON
mom_cycle_feed_rate
Feed rate per minute of the cycle.
mom_cycle_feed_rate_per_rev
Feed rate per revolution of the cycle.
mom_cycle_feed_rate_mode
The programmed feed rate mode of the cycle.
|
Values: |
IPM |
|
|
IPR |
|
|
MMPM |
|
|
MMPR |
mom_cycle_delay
The delay value of the cycle in seconds.
mom_cycle_retract_to applies to all definition events except MOM_bore_manual, MOM_bore_manual_dwell, MOM_drill and MOM_drill_counter_sink.
mom_cycle_delay_revs
The delay value of the cycle in revolutions.
mom_cycle_cam
The cam number of the cycle.
mom_cycle_cam applies to all definition events except MOM_drill_counter_sink and MOM_drill_csink_dwell.
mom_cycle_clearance_plane
The rapid-to point in a cycle event.
mom_cycle_retract_mode
The retract mode.
|
Values: |
AUTO |
|
|
MANUAL |
|
|
blank (not programmed) |
mom_cycle_retract_mode applies to all definition events except MOM_bore_manual and MOM_bore_manual_dwell.
mom_cycle_retract_code
The retract code.
|
Values: |
AUTO = 98 |
|
|
MANUAL = 99 |
|
|
blank (not programmed) = 99 |
mom_cycle_retract_to
The distance that the tool must retract after the machining cycle. This only applies when mode is MANUAL.
mom_cycle_retract_to applies to all definition events except MOM_bore_manual and MOM_bore_manual_dwell.
mom_cycle_feed_to
The depth to which the tool has to move from the top of the hole.
mom_cycle_rapid_to
The distance that the tool must move at a rapid feed rate to position itself above the hole.
mom_cycle_option
Values: OPTION (when set)